Forum topics
IDE to CompactFlash adapter, 44 pin / 2.5" size
Solid state replacement for 2.5" hard disk drives, 44 pin IDE connector.
Mounting hole locations same as the bottom holes of a 2.5" hard disk drive.
Board is configured for cable select. Remove resistor R1 for hard wired configuration, short J2 pins for master, leave open for slave.
Supports IDE DMA.
RoHS compliant
No customer comments for the moment.
Only registered users can post a new comment.
5 other products in the same category:
-
IDE 44 to CompactFlash...
IDE to CompactFlash adapter, 44 pin / 2.5" size, 8 nuts to emulate legacy drives
-
IDE to CompactFlash...
IDE40 to CompactFlash adapter, direct plug onto 40 pin IDE connector, FDD power connector
-
Adaptateur IDE40 vers...
-
Adaptateur IDE40 vers...
-
IDE to CompactFlash...
IDE40 to CompactFlash adapter, direct plug onto 40 pin IDE connector, FDD power connector
